
Cheers lads

Been a bit slow of late

, anyway did do a bit to the motor mounts .
Set up to round the corners , using the angle plate i made earlier and a stop , actually a cam roller from a fuel pump CAV i think .



once set its just a simple job to turn and flip part to do all four corners on both mounts .

Next the motor pocket , more cam rollers used to position the work on the mill .



Next the slots for the motor fixing screws . no DROs in my shop i use gauge blocks and the likes ,no battery's required , after using edge finder to locate position of first slot , lock X stops
for the slot length and Y stop for first slot position , move Y to next slot position and lock stop .
work fist position .

Second position .


Remove gauge blocks , that are set for the pitch of the slots , and slide job down .

Had a nice run up to Scotland today , picked up a new toy ,,,,, thanks Darren


must resist urge to fiddle with it

Rob