« previous next »
Pages: [1]   Go Down

Author Topic: "Fixing Darren's Lathe  (Read 9738 times)

Offline juanito

  • Newbie
  • *
  • Posts: 1
  • Country: us
  • the closer you look the more detail there is.....
"Fixing Darren's Lathe
« on: November 11, 2012, 11:30:08 AM »
Hello everyone,

New to this site!

I recently purchased a Harbor Freight 7x10 mini lathe and am thinkin of converting it to CNC.  In the process of researching how to best go about this task I discovered bogstandard's Youtube video on "Fixing Darren's Lathe" which led me to this site. In reading the thread I am not able to see any of the photos that were originaly posted.  Does anyone know where or how I can see the photos that have been removed or moved by the aouthor :scratch: Any help would be greatly appreciated.

John
Logged

Offline saw

  • Hero Member
  • *****
  • Posts: 1003
  • Country: se
  • lucky amateur
    • Svenssons AckordsWerkstad
Re: "Fixing Darren's Lathe
« Reply #1 on: November 11, 2012, 04:52:17 PM »
Hi and welcome to us  :wave:
Logged
_________________________
Greetings / Benni
http://myprojecty.wordpress.com/category/steam-engine/

Offline andyf

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1795
  • Country: gb
    • The Warco WM180 Lathe - Modifications
Re: "Fixing Darren's Lathe
« Reply #2 on: November 11, 2012, 06:44:31 PM »
Hi John, and welcome.

I'm afraid the photos on Darren's lathe don't seem to be available any more, because they have been removed from Photobucket.

Andy
Logged
Sale, Cheshire
I've cut the end off it twice, but it's still too short
Pages: [1]   Go Up
« previous next »