| Gallery, Projects and General > Project Logs |
| Kennet Tool and Cutter grinder |
| << < (3/13) > >> |
| MadNick:
Morning! Yes, you have quadrupled my normal inbox content this morning! Much appreciated and prefect for finding out what is needed. re The motor your notes said a 1/4hp 1440rpm motor would suffice instead of a 1/6 and this one came up so... Ill have a little look for something a bit more, 'delicate' (like me). N |
| Fergus OMore:
As you have a 'short wheel base' Kennet and mentioned getting it on the the smaller base, I sort of thought- 'ooh, err?' Again, it isn't very protected from gr-gr- grit, is it? OK, change the pulley. Face East and - you know what to look for :clap: You are getting there :beer: |
| MadNick:
Afternoon, I made a quick start on the kennet. Thanks to Norman we were able to identify one of the table supports was missing. I decided to have a crack at making one. I hacked a chunk of this piece of old steel - And spent the afternoon getting things square and clean - Not much to report but its all progress :0 Nick |
| Fergus OMore:
Oh dear, you are behind schedule! :hammer: OK, one bit of plate as a base- bore a hole in the pillar thingy and away we go- laughin' and scratchin' :beer: This way you have a tool and cutter grinder working Cheers N I'm not just a pretty face-- as you will find out-- if ever we get to a Chinese nosh :clap: |
| MadNick:
Im on the case! "I'm not just a pretty face-- as you will find out-- if ever we get to a Chinese nosh" You know what, I may even REQUEST a trip to Newcastle for that pleasure! Nick |
| Navigation |
| Message Index |
| Next page |
| Previous page |