| Gallery, Projects and General > Project Logs |
| Kennet Tool and Cutter grinder |
| << < (4/13) > >> |
| MadNick:
Morning! I was busy last night, working on the missing table support. Thanks to Norman I was able to get an idea of the dimensions. I turned my square block into - To give you some idea - Next I need to cut two slots into this piece, one to fix the pivot you see above, the other in which the pivot will slide. Nick |
| Fergus OMore:
Most impressed on how you have got on with only a bit of sketchy report in an e-mail etc to go on. I am looking forward to it when it is 'all singing, all dancing' and doing the things which it is capable of doing. :beer: |
| DaveH:
Nick Well done :thumbup: :clap: Looking good :beer: DaveH |
| MadNick:
Afternoon, Well so far so good. I milled the top slot out and then chain drilled the inner slot and cleaned it up with an end mill to produce - Exude baby exude! I tack welded the table support square to its base and balanced the whole thing together to give me encouragement to the project - The table support base is located by way of pins and a clamp, I believe. These will be my next step. Nick |
| Fergus OMore:
By now, Nick should( :doh:) have the drawing of the locating peg. I'm going to need a Sabbatical after this :bow: Cheers Norman |
| Navigation |
| Message Index |
| Next page |
| Previous page |