| Gallery, Projects and General > Project Logs |
| Kennet Tool and Cutter grinder |
| << < (13/13) |
| MadNick:
Afternoon :) For anyone that is still following my thread ;) this afternoon I finished off re-making the table support clamp as the one that came with the Kennet was shocking with twisted threads and poor fit. I came up with the following - I also made a rough and ready stop bar out of a square of ali I had knocking around and a ground bar from an old printer - Thats going to be it for a while. I still need to make a couple of holder for the smaller shank end mills but really want to get cracking on my wire bender so I can make a sissy bar/fender stay for the chopper. Nick |
| Navigation |
| Message Index |
| Previous page |