| Gallery, Projects and General > Project Logs |
| Hit n Miss Engine ,,,,to MR D Kerzel's design |
| << < (31/38) > >> |
| Jasonb:
O ring chord I would thin its liek a continuous length of o ring section Looks good Rob, how long did it actually take to machine and also write the programme? J |
| DaveH:
Rob, Very nice. How was it held to the mill fixture plate? :beer: DaveH |
| dsquire:
--- Quote from: sbwhart on June 20, 2011, 12:25:07 PM ---I wonder if we could go through the alphabet with Dave's :D Great stuff Rob :clap: :clap: :clap: :clap: Tell me what are you going to put in that O ring groove, :scratch: Stew --- End quote --- After you are finished going through the alphabet you are going to have to start going by number. I just counted them up and there are at least 29 Dave's. No wonder it's getting confusing. :lol: :lol: :lol: Cheers :beer: Don (not Dave) |
| Rob.Wilson:
--- Quote from: sbwhart on June 20, 2011, 12:25:07 PM --- Tell me what are you going to put in that O ring groove, :scratch: Stew --- End quote --- Hi Stew ,,,,,,, Just as Jason replied ,,,,, i will make one from O ring cord :dremel: Just cut to the required length and super glue the ends :med: --- Quote from: Jasonb on June 20, 2011, 01:31:48 PM ---Looks good Rob, how long did it actually take to machine and also write the programme? J --- End quote --- Hi Jason ,,,,,,, About 3/4 of an hour for the 3D computer model ,,,,,,,,,,,,,, 1 1/2 hours for the CAM /G code part ,, i am still feeling my way around that part and 3 hours 47 minutes of CNC machine time :dremel: --- Quote from: DaveH on June 20, 2011, 02:03:10 PM ---Rob, How was it held to the mill fixture plate? DaveH --- End quote --- Hi Dave ,,,,,,,,,, Four M3 socket cap screws from the underside of the plate screwed into the part were the 4 fixings would go to attach the part to the engine ,the part was spaced up from the fixture plate with 4 washers i had ground to the same thickness ,,,, the holes were then drilled M4 clear and counter bored so it could be bolted to the engine . Don ,,,,,, :doh: how many Dave's :lol: :lol: :lol: :lol: :lol: Rob |
| sbwhart:
--- Quote from: Rob.Wilson on June 20, 2011, 04:52:47 PM --- --- Quote from: sbwhart on June 20, 2011, 12:25:07 PM --- Tell me what are you going to put in that O ring groove, :scratch: Stew --- End quote --- Hi Stew ,,,,,,, Just as Jason replied ,,,,, i will make one from O ring cord :dremel: Just cut to the required length and super glue the ends :med: I recon they would make a good drive belt for a small engine Governor :smart: I'll google O ring cord and see what it brings up Thanks Stew --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |