
G.Day Each,
Well have you spotted my deliberate mistake,see photo 044.
You will notice that the two 3/8" dia. holes in the motor Mounting Plate do not aline with the holes in the Mounting Block.
Now do not ask me how it happened,my only excuse is that i got too complacent.
Now i had visions of having to cut out a new mounting plate but then the old grey matter logged in and it came to me that all i had to do was reverse the mounting plate and remark the security bolt holes.
This would mean that i would have two 3/8"dia. holes with nothing to go in them,who cares.
So I did the necessary and fitted the plate,see photo.048.
The next item was to fit the Motor Mounting units so that the Motor centre is aligned with the Spindle Assembly.
I know that it dose not matter if the Motor and the Spindle are not in alinement but i like to get units on the square with other units.
I am a little concerned that there is no means of adjusting the distance of the Motor to the Spindle.
I realise that the drive belt will have to be made to suit but i like the idea of adjustment.
I had to fit the Motor Mounting units using Countersunk Screws in the Mounting Block side so i also used the same screws for the other Mounting Unit.
Offer assembly up and it fits.so fit the Motor and all looks ship shape.
I now have to switch the brain to informing me as to the Dia.required for the Belt Drive on the Motor.
GerryB