| Gallery, Projects and General > The Design Shop |
| oh no another ball turner |
| << < (5/7) > >> |
| Rob.Wilson:
Looks like you had a good shift in the shop Jason :thumbup: :clap: :clap: :clap: :dremel: You decided what insert you will be using ? I must have a go at making a ball turning attachment :proj: Rob |
| j45on:
"You decided what insert you will be using ?" No not yet :scratch: A TCMT looks the easiest to fit but I also like the double ended VBMT that Ralph used but I cant figure out if I have room I may have made the tool post a bit small it is 1/2" square |
| No1_sonuk:
Mine's no more than 1/2" square at the top, and I use these: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=380251788233&ssPageName=STRK:MEWAX:IT |
| j45on:
--- Quote from: No1_sonuk on September 12, 2010, 05:46:55 PM ---Mine's no more than 1/2" square at the top, and I use these: http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=380251788233&ssPageName=STRK:MEWAX:IT --- End quote --- :thumbup: just ordered some thanks |
| Divided he ad:
Hi Jason, Looking good there :thumbup: The VBMT16 inserts I used are fitted into a 1/2" (well actually 12mm) upright. No bother though, the 11's are the ones I fitted in the mini turner and they cut very well too. Nice of that site to give you all the info on the tips, I had to measure everything and work it all out for myself :smart: I can't remember accurately but I think I showed photo's of the process I used to fit the tips in giving the best support against sideways forces I could, I'm sure I posted a link somewhere on here :scratch: It's been a while since I was here ::) Not long now and we should see your .... Erm, well, spheres :dremel: :lol: Ralph. |
| Navigation |
| Message Index |
| Next page |
| Previous page |