I have cut my gears 10dp with cutters purchased off EBAY £ 20-00 each. I thought it best to keep to this pitch as I didn't want to get in a complete pickle.

If you look at the picture of the engine on the bench you can see the large 50 tooth wheel hasn't had all the teeth cut because I made a bit of an error...

The boiler isn't started I but do have the materials ready. In the main I am using 10 SWG copper plate and as Jason points out you need to play with the tube diameter. It's a trade off between getting in as many flue tubes that are not so small as to get choked or too large as to make the boiler inefficient. Consequently I'm considering using 1/2 inch flues for mine, unless Jason tells me otherwise...

AndyB. Yes I made my own rollers for the front wheels but didn't really make them big enough so had to heat the metal up bright red to get it to roll properly. The rear wheels were made out of a piece of aluminium tube, not to be recommended!
Steve
