| Gallery, Projects and General > Project Logs |
| 90 degree V twin engine (my own design) |
| << < (5/8) > >> |
| Brass_Machine:
:jaw: Looking good so far! Would love to see some on the bender. Eric |
| Darren:
Very, very impressive work :bow: |
| gbritnell:
Hi Eric, I'll post a separate thread on the bender. George |
| Bernd:
Holly exhust pipes batman :jaw: Nice job George. As I was reading this part of the thread I was about to say that I read else were of a guy doing what you were going to do. Then the bulb went on as to where I'd seen this before. :doh: :lol: Hope to see a vid soon of it running. It's got to sound sweet. :ddb: Bernd |
| dsquire:
George It is a pleasure as usual watching you carve the swarf off of a chunk of metal to reveal what is hiding inside. You seem to have such a delicate touch and know just how far to go to get the maximum effect. A real work of art in my book. I will be looking forward to you thread on bending pipes as that is something I think will draw a lot of interest. :ddb: :ddb: Cheers :beer: Don |
| Navigation |
| Message Index |
| Next page |
| Previous page |