| Gallery, Projects and General > Project Logs |
| 90 degree V twin engine (my own design) |
| << < (3/8) > >> |
| Bernd:
Nice looking engine George. Can't wait to see and hear it run. Bernd |
| Stilldrillin:
Beautiful work George..... :thumbup: David D |
| GArat:
Great poject....well done!!! :clap: Best regards Mauro |
| gbritnell:
Today's update. I took the manifold off and bored the hole for the carb. It's a snug fit but will also have a small set screw in the bottom. I then made up an air cleaner cover and back plate. I didn't have enough room between the inlet tube on the carb and the head on the adjusting screws so I made the backplate a little bigger and drilled out the holes for the screw. I then relieved the back side around the boss and screw holes. The cover was machined and buffed, after which I drilled all the holes. I did it this way so that the buffing wouldn't round over all the holes. I thought that a shiny piece or two would contrast the finishes on the rest of the pieces. George |
| gbritnell:
A few more shots. George |
| Navigation |
| Message Index |
| Next page |
| Previous page |