| Gallery, Projects and General > Project Logs |
| Myford Taper Turning Atahment AGIAN |
| << < (8/15) > >> |
| outlawspeeder:
That is the best tapering tool I have seen and plan on doing one in the new year following this layout. I am looking for the bluing "how to" but can't find it. Did it get done? Does someone have a how to? |
| raynerd:
Rob, amazing !!!!!! :drool: I`m with Dean - please tell us how you got the finish on the handle! Chris |
| outlawspeeder:
I have bought this back from 2009. Rob are you there? |
| krv3000:
well dun rob |
| Rob.Wilson:
Thanks Chris and Bob Welcome to Madmodder outlawspeeder Its a very basic process to build up an oxide layer on the part , polish your part ,then CLEAN the part and dont touch it with your paws , you will get grease transfer from your fingers ,were gloves , then evenly heat the part to the desired colour and plonk it in a tub of clean oil . Rob Edit : forgot to say 3 years on the blued parts still look as good no rust |
| Navigation |
| Message Index |
| Next page |
| Previous page |