| Gallery, Projects and General > Project Logs |
| Myford Taper Turning Atahment AGIAN |
| << < (15/15) |
| Rob.Wilson:
Here's a few photos Lets no if you need any more :thumbup: Rob |
| outlawspeeder:
The third photo you added is the big ticket!! Wow I thought the pin coming up was threaded and a tight mount from the cross slide to the top of the slide. I am so happy I didn’t work on that part yet. So I have the rail mounted. It stand off the back at 1.75 inches on 5 bolts. Going from the bottom rail in the back to the top closest edge I have a run out of .0014 over the four foot run. I checked it at mid and its .0009. Not bad for a hand drill. I used the rail as a drill guide with drill guide inserts made for this. One end, see photo (#1), is just clamping across the top of the lathe. This was due to the removable bed. Thanks for the pics, it is helping SO much!!! :D |
| Rob.Wilson:
Nice job of fitting the guided rail :clap: :clap: :clap: positioning the TTA will be a breeze :med: Rob |
| Navigation |
| Message Index |
| Previous page |