Myford Taper Turning Atahment AGIAN

Gallery, Projects and General > Project Logs

<< < (3/15) > >>

sbwhart:
Very nice work ROB :clap: :clap: :clap:

I like your thinking ahead with the case hardening and tapping the screws, Just how big are these parts that dove tail slide must be about 4" * 6" ?

Thanks fro showing

Stew

Rob.Wilson:
Thanks Stew

the slidder part is about 3 1/2 X 2 1/2 X 1 1/4 ,,,,Note to self ,,must put some thing in shot for scale :doh:

The next part to be made was the link that connects the lathe cross slide to the TTA
this was milled up from some flat stock to leave the center section high

then a slot and the hole for a t bolt to fix it to the cross slide

then i set it up on a angle plate to mill the tapperd section

set up on the R/T to have the ends milled ,

then it was finished off with a file to add a radus around the top edge

still a couple of holes to drill

Regards Rob

Rob.Wilson:
Hi All

next out with the piant

then i made some of the smaller parts that join everything together

right were up to date now ,, tonight i hope to get some shop time and do a bit more

Regards Rob

sbwhart:
Stunning Job Rob

:clap: :clap: :clap: :clap: :clap: :clap:

Stew

dsquire:
Rob

You have done a superb job of both machining and finishing the Myford Taper Turning Attachment as well as documenting it so that others may use it as an example when building their own. You have every right to be proud of this build and MadModder is a better forum because of it. Thanks again for re-posting this for all of us.
:D :ddb: :D:ddb: :D :ddb: :D

Cheers :beer: :mmr:

Don

Navigation

 Message Index

Go to full version