Gallery, Projects and General > How do I??
Rotary Table Chuck Adaptor Plate
Stilldrillin:
--- Quote from: sbwhart on June 16, 2009, 03:06:27 AM ---I'm happy with what I've got :D
Stew
--- End quote ---
"Who could ask for anything more"........ :thumbup:
David D
sbwhart:
Ok the loctite as done its thing and curred, so skim up the 72mm diameter register for the chuck.
Then fix it on the RT with a cap screw up the back end as a draw bar, the head of the cap screw needed thining so it wouldn't stick out of the back of the RT, clocked the plate up to bring it on the quill centre line, indexed the table over 42mm to give a pitch circle diameter of 84mm and drilled the fixing holes 8.5 mm dia (wiggle room for the M8 bolts) using the index plate to get the three hole positions.
Tried the chuck on, and it fits like a gloves, finger space just right for getting the screws into the back of the chuck :thumbup:
This is what it will do.
Turn a diameter on a bar (this is for some hand wheels)
RT recentred simply by winding the table back to the zero position,
Chuck clamped on RT and holes drilled using index plate, because job was left in chuck these holes are dead concentric to the OD of the bar.
Mext job transfer chuck back to lathe to finish off the handles (I'll show that later), again everything will be dead concentric.
I'm happy how this is working out I think I've got a real usfull bit of kit.
Her's a pic of my Boses Choclate refrigorator cake
MMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMM
Have Fun
I'm off to have a bit of tea and cake
:D :D :D :D :D
Stew
Stilldrillin:
Now I understand...... :thumbup:
:
--- Quote from: Darren on June 16, 2009, 04:31:08 AM ---They look very nicely done David,
Now I know how I'm going to tackle one of my little engine tasks :thumbup:
--- End quote ---
Don`t you think it`s a bit cruel showing chocolate heaven, this time of a morning........ :lol: :lol:
David D
sbwhart:
--- Quote from: Stilldrillin on June 17, 2009, 03:34:41 AM ---
Now I understand...... :thumbup:
:
--- Quote from: Darren on June 16, 2009, 04:31:08 AM ---They look very nicely done David,
Now I know how I'm going to tackle one of my little engine tasks :thumbup:
--- End quote ---
Don`t you think it`s a bit cruel showing chocolate heaven, this time of a morning........ :lol: :lol:
David D
--- End quote ---
Darren little engine quote :scratch:
Confused
It must be the choclate set up an inbalance in my system :zap:
:lol:
Stew
Stilldrillin:
Oh my......... :bugeye: :bugeye:
Now, I`m doin` it....... :scratch: :scratch:
Well..... There`s no answer to THAT!........ :bang:
:lol: :lol: :lol: :lol: :lol:
From a confused/ bemused,
David D......... (Not Stew, or Darren either).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version