The Shop > CNC
DDCSV1.1 4 Axis controller
ryan8:
I did have probing enabled with no probes connected. Disabled it in config - hope this fixes it and thanks for the suggestions!
blades:
Hoping someone can help me out identifying this component. While making a new enclosure for my controller, I managed to fry it by attempting to share the same power supply with my G540. :Doh:
It was a 48v power supply that I backed down to 32v (as low as it would go), but it must have gotten a spike and it literally blew this component. I've got it unsoldered from the board, and want to see if I can replace it. I can't read it clearly enough on the pics I've found. Any help with a better pic or actual part identification would be greatly appreciated! I'm guessing it's some sort of voltage regulator...
maxx2000:
XL2596S-5.0E1
awemawson:
Highly probable, as XL2596S-5.0E1 is a DC to DC converter so presumably was in the direct firing line from your higher voltage power supply.
blades:
Many thanks guys!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version