The Shop > CNC
DDCSV1.1 4 Axis controller
blades:
--- Quote from: ryan8 on March 31, 2018, 07:21:37 PM ---... I've tried updating to Pandora with the same results.
--- End quote ---
So you're saying it started doing this when you were still using the OEM firmware?
ryan8:
--- Quote from: blades on April 16, 2018, 08:17:52 PM ---
So you're saying it started doing this when you were still using the OEM firmware?
--- End quote ---
Yes; I was hoping it was a firmware issue that would go away if I updated.
--- Quote from: johnsattuk on April 14, 2018, 03:04:23 PM ---Optoisolaters give galvanic isolation and some degree of filtering, ( depending on their speed ), but they will pass a transient through if it has similar properties to a bona fide signal
--- End quote ---
Ah, that makes sense. A guy on the tech support forums suggests that it could be phantom limit switches being triggered. Though I don't have limits enabled, it does fit with the "other axis will still work" weirdness.
--- Quote from: Will_D on April 15, 2018, 05:58:57 AM ---
I am starting to suffer this but only on the z axis. It will jog down but not up. Power off and wait resets it.
I am running the [Install_2018-01-21_91] new 2.1 version.
I may well go back to the stable 2017 version for 1.1
--- End quote ---
When it freezes, do your other axis still work?
Will_D:
--- Quote from: ryan8 on April 22, 2018, 07:33:21 PM ---
--- Quote from: Will_D on April 15, 2018, 05:58:57 AM ---
I am starting to suffer this but only on the z axis. It will jog down but not up. Power off and wait resets it.
I am running the [Install_2018-01-21_91] new 2.1 version.
I may well go back to the stable 2017 version for 1.1
--- End quote ---
When it freezes, do your other axis still work?
--- End quote ---
Yes X and Y are unaffected
Will_D:
I suspect its connected with probing!
When Z+ stops working, if I do a probe Z+ it starts to probe DOWN at a stupidly slow rate! Its as if it thinks it has found the limit switch at Z+ and is now very very slowly coming off the micro-switch in the Z- direction ( as it should do fairly quickly) to the probe offset position (5mm in my case)
HTH Will
BTW the DoseDone forum has gone a bit quiet recently!!:
http://www.ddcnc.com/forum.php?mod=forumdisplay&fid=41
WeldingRod:
--- Quote from: Will_D on April 23, 2018, 05:27:44 AM ---I suspect its connected with probing!
When Z+ stops working, if I do a probe Z+ it starts to probe DOWN at a stupidly slow rate! Its as if it thinks it has found the limit switch at Z+ and is now very very slowly coming off the micro-switch in the Z- direction ( as it should do fairly quickly) to the probe offset position (5mm in my case)
HTH Will
BTW the DoseDone forum has gone a bit quiet recently!!:
http://www.ddcnc.com/forum.php?mod=forumdisplay&fid=41
--- End quote ---
I have noticed an axis stopping semi-mysteriously, but it's always been a triggered limit switch.
Sent from my SAMSUNG-SM-G891A using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version