The Shop > CNC
DDCSV1.1 4 Axis controller
<< < (153/202) > >>
antonio:

--- Quote from: chriscnc on November 23, 2017, 12:50:22 PM ---@antonio

Testing backlash, is it not using it at all or is there an error in the arc? please run with line 113 on then off to compare. Turn off only if you mach has the same steps per/mm x/y

--- End quote ---

hi Chris,
I'm using the latest original firmware but backlash is not used during a circle even the backlash and parameters (0,15 x and 0,15 y) on varset is setted on for x and y too.
Benedikt:
Good evening!

It seemed many people had issues with the firmware update process, so I have developed a small Windows assistant to guide you through the installation of Pandora.
What makes it so much easier is, that the assistant detects all removable drives, shows which ones are compatible for the installation, and allows reformatting incompatibly formatted sticks in the proper format. Also, all files are copied to their proper locations making sure, the installation will work well.
Afterwards, the USB stick is ejected and a short tutorial is presented that leads through the remaining steps.
It's great to have so many different people here and not anyone here has a degree in IT so it's kept as simple and straightforward as possible. I think the mechanical work most of these people show here is just plainly amazing :D

Here are a few screenshots, because  :worthless:



It can be downloaded from here: http://dl.pandora-cnc.eu/utils/installer/PandoraInstaller_20170416a.exe


Best regards,
Benedikt
blades:
NICE work Benedikt! Many thanks!! Haven't tried it yet, my machine is still in temporary storage from moving. Looking forward to trying it out!
johnsattuk:
 :thumbup:
Will_D:
Thanks Benedikt.

Will Pandora instal overwrite my existing parameter settings?
Navigation
Message Index
Next page
Previous page

Go to full version