The Shop > CNC
DDCSV1.1 4 Axis controller
<< < (152/202) > >>
chriscnc:
@Benedikt M.

Send me a PM ill loop you in with the factory team direct.
blades:
Hey Chris, has there been any update on the DDCSV ver. 2 you mentioned back on pg. 28?
merc:

--- Quote from: chriscnc on November 23, 2017, 12:42:06 PM ---This is a gcode issue, what software did you make the code with? Ive been running the new firmware non-stop as well as the factory and its not had any faults yet. Ill run your code to make sure i get the same.

--- End quote ---

Its Mastercam. Same gcode works fine with cnc controlled by NCStudio. Also, any simulator will show the difference between video and simulator.
ugv:
Avis:
They know if they have solved the problem of accidental deletion of the software with the mode key and if that is the case where I can download the last factory version.
Thank you
Navigation
Message Index
Next page
Previous page

Go to full version