The Shop > CNC |
DDCSV1.1 4 Axis controller |
<< < (151/202) > >> |
Will_D:
Talking of backlash: Is this now working in the current release? |
Benedikt:
Status update: My controller is now repaired and seems to be operational again. I have started to binary patch the latest version of the firmware that has been posted by chriscnc. This may take a while. How is that one version working for the most of you? Is it stable enough to be used productively? @ChrisCNC, please provide some info on the FPGA registers. This would really help! Don't fear anything. There is no way we're going to steal any profit from you. We've got most of the software source (minus the comments and the names of the functions local variables) already, but some FPGA doc would really help. Beat regards, Benedikt |
merc:
--- Quote from: Benedikt M. on November 23, 2017, 07:28:10 AM ---This may take a while. How is that one version working for the most of you? Is it stable enough to be used productively? --- End quote --- --- Quote from: merc on November 21, 2017, 04:26:20 AM ---Hi! I flashed this firmware to my cnc and have a problem with arcs. Here is short gcode and video: gcode: https://gist.github.com/arrowcircle/30017c506a6883d7ab227eae4f3af698 video: Problem is, when it makes second tab it does not stop and goes additional 360 degrees without lifting a tool. Is this a bug? Or do I doing something wrong? --- End quote --- |
chriscnc:
This is a gcode issue, what software did you make the code with? Ive been running the new firmware non-stop as well as the factory and its not had any faults yet. Ill run your code to make sure i get the same. |
chriscnc:
@antonio Testing backlash, is it not using it at all or is there an error in the arc? please run with line 113 on then off to compare. Turn off only if you mach has the same steps per/mm x/y |
Navigation |
Message Index |
Next page |
Previous page |