The Shop > CNC |
DDCSV1.1 4 Axis controller |
<< < (150/202) > >> |
maxx2000:
--- Quote from: merc on November 21, 2017, 09:48:24 AM ---Problem is it ignores safe height and just move tool for a full circle instead of making a pod --- End quote --- see the settings of the processing strategy of your CAM system. Point out that the tool should be taken to the initial height after the operation is completed. Your problems are the result of incorrect programming. |
merc:
--- Quote from: maxx2000 on November 21, 2017, 10:15:29 AM --- --- Quote from: merc on November 21, 2017, 09:48:24 AM ---Problem is it ignores safe height and just move tool for a full circle instead of making a pod --- End quote --- see the settings of the processing strategy of your CAM system. Point out that the tool should be taken to the initial height after the operation is completed. Your problems are the result of incorrect programming. --- End quote --- Please try to simulate gcode I sent and compare it with video - they are really different, look on second tab. This is not a problem of CAM. Same GCODE on different controller works fine and equal to simulation. |
maxx2000:
--- Quote from: merc on November 22, 2017, 01:33:29 AM ---Please try to simulate gcode I sent and compare it with video - they are really different, look on second tab. This is not a problem of CAM. Same GCODE on different controller works fine and equal to simulation. --- End quote --- I saw your code, you do not have a gap in the G code between the cuts to a safe height. The cutter, after passing through the circle, is deepened by 1 mm and cuts further. At me your code is fulfilled exactly as you programmed it. Learn or change your CAM system. Either manually add lines containing a lift to a safe height |
merc:
--- Quote from: maxx2000 on November 22, 2017, 02:07:31 AM --- --- Quote from: merc on November 22, 2017, 01:33:29 AM ---Please try to simulate gcode I sent and compare it with video - they are really different, look on second tab. This is not a problem of CAM. Same GCODE on different controller works fine and equal to simulation. --- End quote --- I saw your code, you do not have a gap in the G code between the cuts to a safe height. The cutter, after passing through the circle, is deepened by 1 mm and cuts further. At me your code is fulfilled exactly as you programmed it. Learn or change your CAM system. Either manually add lines containing a lift to a safe height --- End quote --- I dont know how you seen the video and simulation. In simulation on the second tab it moves through the tab for 30 degrees, however in video it moves for 390 degrees. And please read my problems. Same code on another controller works fine and exactly like in simulation. So please dont advice to check CAM settings, its controller related problem. |
Muzzerboy:
BTW, dunno if you saw "https://ncviewer.com/" written by one of the Fusion boys. Quick and simple way to check out your toolpaths. Muzzer |
Navigation |
Message Index |
Next page |
Previous page |