The Shop > CNC |
DDCSV1.1 4 Axis controller |
<< < (149/202) > >> |
maxx2000:
It's not a problem. Tell me, why raise the instrument? To make the program run longer? |
merc:
--- Quote from: maxx2000 on November 21, 2017, 05:56:12 AM ---It's not a problem. Tell me, why raise the instrument? To make the program run longer? --- End quote --- It is a problem. My cnc goes through material. In this example its only 1mm. I catched that bug on 16mm of depth and broken the tool. |
antonio:
Hi chriscnc It seems ther is some problem with arc interpolation in last original firmware due to not calculate the backlash during movments.. is it the new firmware fix this problem? Inviato dal mio iPhone utilizzando Tapatalk |
maxx2000:
--- Quote from: merc on November 21, 2017, 07:31:46 AM ---It's not a problem. Tell me, why raise the instrument? To make the program run longer? --- End quote --- It is a problem. My cnc goes through material. In this example its only 1mm. I catched that bug on 16mm of depth and broken the tool. [/quote] Set a safe height greater than the total depth of processing |
merc:
--- Quote from: maxx2000 on November 21, 2017, 08:22:07 AM ---Set a safe height greater than the total depth of processing --- End quote --- Problem is it ignores safe height and just move tool for a full circle instead of making a pod |
Navigation |
Message Index |
Next page |
Previous page |