« previous next »
Pages: 1 ... 3 4 [5]   Go Down

Author Topic: The CNC experiment build.  (Read 60810 times)

Offline NeoTech

  • Hero Member
  • *****
  • Posts: 826
  • Country: se
    • Roughedge Hobbyworks
Re: The CNC experiment build.
« Reply #100 on: April 14, 2015, 03:25:21 PM »
Well gray is stylish.. will pour flooring epoxy at a later stage getting a 2-3mm thick protective surface. =)
Logged
Machinery: Optimum D320x920, Optimum BF20L, Aciera F3. -- I have not failed. I've just found 10,000 ways that won't work. http://www.roughedge.se/blogg/

RobWilson

  • Guest
Re: The CNC experiment build.
« Reply #101 on: April 14, 2015, 03:28:42 PM »
Nowt wrong with Grey , the floor dose look belting  :thumbup: , how long before you can give it a coat of sealer and get things moved back in ?


Rob 
Logged

Offline NeoTech

  • Hero Member
  • *****
  • Posts: 826
  • Country: se
    • Roughedge Hobbyworks
Re: The CNC experiment build.
« Reply #102 on: April 14, 2015, 04:25:37 PM »
Guessing it will take a 4-6 weeks or so.. i can use the floor from a week from now, but not seal it until later.. humidity would make it crack if i did. =)
Logged
Machinery: Optimum D320x920, Optimum BF20L, Aciera F3. -- I have not failed. I've just found 10,000 ways that won't work. http://www.roughedge.se/blogg/

Offline NeoTech

  • Hero Member
  • *****
  • Posts: 826
  • Country: se
    • Roughedge Hobbyworks
Re: The CNC experiment build.
« Reply #103 on: June 22, 2015, 01:32:31 PM »
So after several detours my shop is coming together, only some electrics and new doors left.



My new compressor arrived a tad bit early, you can see it on the left there..
And this is from when i moved it in there.. by myself, by hand.. its effin 220kg..

Logged
Machinery: Optimum D320x920, Optimum BF20L, Aciera F3. -- I have not failed. I've just found 10,000 ways that won't work. http://www.roughedge.se/blogg/

Offline NeoTech

  • Hero Member
  • *****
  • Posts: 826
  • Country: se
    • Roughedge Hobbyworks
Re: The CNC experiment build.
« Reply #104 on: July 16, 2015, 04:34:06 PM »
And it finally is time to move in..
Got lights up, gates inserted, electricity is drawn.. at last.. time to get back to the cnc part of this thread..

Logged
Machinery: Optimum D320x920, Optimum BF20L, Aciera F3. -- I have not failed. I've just found 10,000 ways that won't work. http://www.roughedge.se/blogg/
Pages: 1 ... 3 4 [5]   Go Up
« previous next »