Gallery, Projects and General > Project Logs
Cheepo toolpost grinder
<< < (2/4) > >>
John Rudd:
Watching with interest...
Looks good so far.. :thumbup:
chipenter:
Bit more done this morning screw cut and bored a piece to hold the front bearing , and some sleaves to clamp the inner races together ,cut for woodruff key for the pulley this is the only thing I will do to the spindle as it has a 5mm hole right through tapped 6mm ,
John Rudd:
Is that a home made Woodruff cutter? :dremel:

You've made good progress...

Cant wait to see it finished and working :clap:
chipenter:
Is that a home made Woodruff cutter?  I wish I could make one with tungsten tips like that so it's a no ,
pressed the front bearing in a bit too tight and not as free as it was , I have a piece of 63mm ally 1.8m long for the pully on the motor and will make one 20mm for the drive gives me 3:1 at 4275 RPM , iff thats to slow I will have to cast a bigger one. 
DavidA:
A handy tool.

I also was wondering about repeatability when using it it a three jaw. 

Dave.
Navigation
Message Index
Next page
Previous page

Go to full version