Gallery, Projects and General > Project Logs |
Cheepo toolpost grinder |
<< < (3/4) > >> |
chipenter:
Got a lot done today bolted the carrier to a peice of 1\4" plate with a 1\2" square riser , hade to take off 15 thou toget it to centre height ,made some polly v pullys 70mm and a 20mm , I didn't have a 12mm guide for my broach just used the packers whithout a guide , the motor came with a fan not a good idea whith grinding dust about however the cast ally cover will make a belt guard , also tested the run out at first it was 8 thou but it rocked modified a c spanner once tight 1\2 a thou and repeatable , I was more than happy with that . |
millwright:
All coming together well and looking good now Jeff. John |
chipenter:
Got it togeather cut some slots for the belt cover , tempery wired it up and it runs backward swapping the capaciter wires round didn't change the direction , I need a metal box for the terminals to make it safe . |
BillTodd:
those smaller motors usually have identical start and run winding (check resistance). Reversing only requires swapping the live to the other side of the cap . bill |
Ginger Nut:
I'll follow if I may |
Navigation |
Message Index |
Next page |
Previous page |