Afternoon lads
![:dremel:](https://madmodder.net/Smileys/default/smiley_dremel.gif)
Not allot done , been a bad week
![:coffee:](https://madmodder.net/Smileys/default/kaffeetrinker_2.gif)
. Made up a few bushings ,three plane and three threaded 1/4 BSW pressed those into the jaws , then made the guide pins , hardened .
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060299.jpg)
A quick polish and and these were then pressed into the fixed jaws
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060307.jpg)
A bit of a side note , came in to the house to make a brew , found the wife had been doing something with here hair , spies this handy bottle in her hands .
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060300.jpg)
Looking at it I thought hand wee oil bottle , So off came the label before Micktoon calls me gay AGAIN !
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060305.jpg)
It has a nice small nozzle with screw on cap .
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060301.jpg)
Back to the vice's ,rounded the ends of the moving jaw.
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060294.jpg)
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060311.jpg)
I sill need to make the screws , but thought I would have a bit mess on so i stuck a 1/4 screw in to try out one of the vice's .
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060312.jpg)
had ago at filling the hole square
![:palm:](https://madmodder.net/Smileys/default/facepalm.gif)
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060314.jpg)
![](http://www.nam-engineering.com/cm/albums/userpics/10002/normal_P1060315.jpg)
I need glasses
![Doh :Doh:](https://madmodder.net/Smileys/default/Doh.gif)
Cheers Rob