« previous next »
Pages: [1]   Go Down

Author Topic: Machine Tool Shanks and their Tapers  (Read 7117 times)

Offline Bernd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3688
  • Country: us
  • 1915 C Cab
    • Kingstone Model Works
Machine Tool Shanks and their Tapers
« on: February 17, 2010, 03:13:34 PM »
Here's a link that some might find informative and helpful.

If your into making your own tooling or need to find out what taper is on that mystery tool. This web site might be able to help out.

Machine Tool Tapers

Bernd
Logged
Route of the Black Diamonds

Offline andyf

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1795
  • Country: gb
    • The Warco WM180 Lathe - Modifications
Re: Machine Tool Shanks and their Tapers
« Reply #1 on: February 17, 2010, 03:32:59 PM »
Nice link, Bernd. Isn't it just great to have a wide choice between so many "standards"  :bang:

One common style seems to be missing, though - the DIN tapers which are in effect Morse with either the fat end or the thin end cut off to shorten them. Details of those, and some of the others mentioned in your link, can be found at
http://www.jacobschuck.com/pdf/Technical-Information.pdf

Andy
Logged
Sale, Cheshire
I've cut the end off it twice, but it's still too short

Offline Bernd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3688
  • Country: us
  • 1915 C Cab
    • Kingstone Model Works
Re: Machine Tool Shanks and their Tapers
« Reply #2 on: February 17, 2010, 08:34:06 PM »
Thanks for adding on to the thread Andy.

I found this place when I was looking for the Kwik Change arbors #200 for my Bridgeport. Looks like I might atempt to make my own one of these days.

Bernd
Logged
Route of the Black Diamonds
Pages: [1]   Go Up
« previous next »