Large Fly cutter

[Darren]

I wanted to make a large fly cutter, this one will sweep about 6"

Starting with a blank of alloy to be faced and trued up

Large Fly cutter

Two sides faced and then fitted to my slitting saw arbor to machine the circumference true. A new end cap needs to be made.

Large Fly cutter

The start of the new end cap, machined one end down to 1"

Large Fly cutter

Fitted in a collet and turned around

Large Fly cutter

New end cap finished

Large Fly cutter

All that needs doing now is to mount the cutting tool bit ...

Large Fly cutter

[Rob.Wilson]

Hi Darren  ,and happy new year

A large fly cutter is some thing i to could do with ,,what are you going to use for the cutter?  i have a good few TCT tips with no tool to fit them i was thinking of using them on a single point fly cutter ,well when i come up with away of mounting them.

Regards Rob

[Darren]

Hi Rob,

The plan is to skim a cylinder head at some point. I'm not sure yet if this cutter will be big enough, if not I will make a bigger one as only the alloy disk needs to be re-made. But I think this one will just about do.

Now got to think of a way to mount the cutter, might have to be at an angle to gain a larger throw. Shouldn't be too difficult once I have put some thought into it  

Happy new year to you and all too 

[raynerd]

Looking good Darren, don`t think it would fit in my little mill lol

[sportandmiah]

Any luck mounting the cutter? Pics pls!

[Darren]

Sorry it did get any further than this as the suspected head damage turned out not to exist, in fact it was in very good condition and didn't need skimming after all.

One day I will need this tool and will be fitting the cutter.

[troup]

A good source of free, high grade material for large fly cutters is discarded brake disks (aka rotors) - brake repair shops have wastebins full of them. HIgh grade cast iron, nicely seasoned, machine up nicely.