8 mm wire cable aluminium crimp die dimessions

[PekkaNF]

I need to use oval aluminium swage ferrules to rig standard steel cable.

Bit like this:
https://www.e-rigging.com/How-to-Select-and-Use-Swage-Sleeves

Local shop had cable and ferrules etc. But nothing to crimp ferrules. I need to terminate only few - does not warrant for really expensive dies and press.

I probably could make a simple jig/crimp, but I have no good idea to what ID and width should the die be.

Any advice?

Thank you,
Pekka

[Will_D]

Excellent link, that needs saving for future reference

[WeldingRod]

Do you have/can get access to a finished one to measure?  Spring back on those should be minimal...  just make a cavity to match the finished part.
Otherwise you need to experiment and load test :-(

Sent from my SM-G892A using Tapatalk

[timby]

This video will give you a good idea of what is needed, I suggest making something up to fit your vice.

https://youtu.be/sAzbzRaSBOQ

[PekkaNF]

Thank you. Here those pliers are common up to 6 mm steel cable size and then whole lot bigger hydraulic ones.

I think that gauge diameter is close to 18 mm with the 8 mm ferrules I have. If I read the tables right I need 30 metric tons to press the dies.

There must be something (like hydraulic swage) in German e-bay. I'll trawl in the evening, after I get home.

This looks interesting:
https://www.youtube.com/watch?v=jBlvFRDHdgM

Maybe something like this:
https://youtu.be/RoZpqvBsNAw

I wish I had the dimenssions for the critical parts, therefore I asked.