Gallery, Projects and General > Project Logs

Mogas makes something.

<< < (2/3) > >>

Mogas:
Center punch the holes.

Mogas:
Tap to M3
I used the drill chuck with a center in it to keep that little tap straight.

Mogas:
Result!
Just a note: When I tried the tool, I found that there was not enough relief angle on the carbide tip when offered up to the job. The M3 screw was slackened off and a .4mm shim made out of old crate strapping inserted, giving just the right relief.
A little cleaning up with a file and the end result is a sturdy set of tool holders.
Over all, a very satisfying exercise!  :thumbup:

Brass_Machine:
Good job Mogas.

I am going to attempt this in the not too distant future. Thanks!

Eric

sbwhart:
Nice one  :thumbup: I'm shure this will be usful to the chaps.

Stew

Navigation

[0] Message Index

[#] Next page

[*] Previous page