Gallery, Projects and General > Project Logs
Mogas makes something.
Bernd:
Nice Mogas.
Another option would be to grind the clearence angle on the side of the carbide tool with a green wheel or diamond wheel. You'll then only have 3 useful position to use instead of 6. It'll will also eliminate the use of a shim.
Regards,
Bernd
jemglen:
Enlightening and well documented, thank you :clap:
Jerry
Darren:
Nicely done mogas, see you took a little more effort than I did. :thumbup:
What size tips are you using?
Mogas:
--- Quote from: Darren on April 01, 2009, 01:20:30 PM ---Nicely done mogas, see you took a little more effort than I did. :thumbup:
What size tips are you using?
--- End quote ---
Sorry, I don't even know what size they are :scratch:, 16mmx16mmx16mm I guess about 09 judging by your thread. My tooling supplier lets me into the Aladin's cave and I just picked up off the shelf what looked likely to work.
BTW, I have not given them a full performance test as you did Darren :clap: but I am sure they are up to it, not sure about my machine though!
Thank you all for the kind words.
My next project will be a home made parting tool holder, I will be posting some pictures and seeking advice!
Darren:
I'm certainly no expert but it sounds like the same size as I used, 09, :thumbup:
Navigation
[0] Message Index
[*] Previous page
Go to full version