Gallery, Projects and General > Project Logs
Bengs, Flame Eater. "Nick".........
Stilldrillin:
Frazer.
The next piston won't look like that one, either! :thumbup:
Just got to decide, what material to use....... :scratch:
Interesting animations and info. :smart: Thanks!
David D
fcheslop:
See other channel
cast iron if you dont want to get in bother.Iv two graphite bits to make and I hate the filthy stuff but needs must
Wor lass winnet be pleased
cheers
Stilldrillin:
By 'ek! It's more than two months, since work stopped on this engine! :palm:
From the last line, of the last post. I actually did, "get on with it", at the time.........
Turned a 12mm dia mandrel.......
Then turned/ polished the piston to a nice fit in the cylinder......
Temporary assembly. Losing one of the M2 nuts, in the process.
It still runs! Now, needing no warm up! :D
I now, need to think of an "eyebrow", over the flame/ port area.
And, that's the point where it all stopped........ :(
David D
vtsteam:
Runs very nicely, David! I like the solid appearance of that engine, too. The parts look robust, and it gives the impression of power to see masses swinging around -- even if the actual power is low. Excellent little engine!
:thumbup: :thumbup: :bow: :bow: :beer:
AussieJimG:
Well done David, it is always a pleasure to follow your re-builds.
Jim
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version