Gallery, Projects and General > Project Logs
surface grindy type project
<< < (13/17) > >>
shipto:
The plc programming has been a bit of a headache but I have finally sorted it and everything is working as expected now  :ddb:
shipto:
Decided to give it a little test by grinding the table top I am quite pleased. About the straightest thing i have in the shop is the ruler off my set square which I wouldnt guarantee but its probably close enough for my needs and the red area in second picture marks a place where I can slide a rizla paper under the ruler. everywhere else is too close to get it under.
Stilldrillin:
That's great Shipto!   :headbang:

I think the wheel needs racing, for an improved finish.   :smart:

By the way...... I'm sure, it's your rule which is bent....... :thumbup:

Love it!   

David D
shipto:
Thanks Stilldrillin the wheel definatly needs changing the one on there is pretty bad but I will get another one once I have mounted magnets and made a jig to true it up. still have much to do like the mentioned magnets and guards which will include wipers and brushes to keep the guide rail clean. need to figure out how I am going to keep the muck from going under the table too, The linear bearings have wipers of their own but I still want to stop as much as possible going onto rails.
nel2lar:
A good vacuum system will do the trick.
Navigation
Message Index
Next page
Previous page

Go to full version