Gallery, Projects and General > Project Logs
surface grindy type project
<< < (9/17) > >>
Stilldrillin:
It's great to see some animation!   :thumbup:

I've been puzzling/ following. But have had nothing to add......  :scratch:

Looking/ sounding good. Well done!   :clap: :clap:

David D
DavidA:
Shipto,

... do you think the bloody cv's would split from the shafts ...

The reasoning here is that a split cv boot will throw out all the grease and this could cause the joint to dry out and size up.

Would you want a drive shaft to suddenly start thrashing about when you are driving along ?

Interestingly,  it is only the outer boots that the tester is worried about.

Dave.
shipto:

--- Quote from: DavidA on July 11, 2014, 04:42:14 AM ---Shipto,

... do you think the bloody cv's would split from the shafts ...

The reasoning here is that a split cv boot will throw out all the grease and this could cause the joint to dry out and size up.

Would you want a drive shaft to suddenly start thrashing about when you are driving along ?

Interestingly,  it is only the outer boots that the tester is worried about.

Dave.

--- End quote ---
Had to look back to see what i had said here, I wasnt questioning the reason for cv boots failing but commenting that I couldnt get the cv split fron the shaft to replace the boot, didnt go into much deatil because its not a car forum but i ended up having to take the shaft completely out and stripping the other side to get them on.
shipto:
No major progress today just added the block for the screw.
nel2lar:
Shipto
I have a chain set up that moves to the right then turns and goes to the left. I can kind of draw up something if you would like to see it. I found the mechanics when I tore down a ink tray mixer on a printing press. It's not anything hard and could possibly be able to set the two point on reverse direction to what you want. Let me know and I will try to make a sketch.
Nelson Collar
Navigation
Message Index
Next page
Previous page

Go to full version