Gallery, Projects and General > Project Logs
surface grindy type project
<< < (8/17) > >>
mattinker:
That's fun! Looking good!

Regards, Matthew
PekkaNF:
Very nice!

When you'll have tested and adjusted it would you publish a bit of info how flat surface it produces. It looks pretty good.

Pekka
shipto:
 I will do my best but I don't have much equipment to measure it accurately the best I could do would be to lay some paint on the granite chopping board I nicked of the wife and show the results of that.
shipto:
I am fairly happy with the left/right movement now and its time to turn my thoughts to the back/forward which for the sake of less typing I will now call X and Y.
I have stripped down a old 9.6V drill a friend gave me and salvaged the motor and gearbox. Then I stripp down the gearbox and sawed the shaft shorter before facing it off, drilling and tapping the center for a m6 screw.
Next I made the mount for it from a block of aluminium, still have to drill and tap the block to mount it on machine but will do that after I work out the rest of the mechanism.
shipto:
Had to gather together some of the bits I threw away as I forgot to take the torque limiter mechanism into account, I could have just locked the mechanism but thought if I could find the bits it would be a handy function. So found them and installed them, then mounted the setup on the table.
Only problem now is that I am getting a bit fixated on this and am neglecting to do the jobs I should be doing, example I have had a replacement wheel arch for the camper for nearly a month now and not got it on the vehicle yet oh well :Doh:
Navigation
Message Index
Next page
Previous page

Go to full version