Gallery, Projects and General > Project Logs
The Rainbows Engine.......
<< < (3/7) > >>
tom osselton:
  looks and runs good, I haven't looked into these type of engine yet but it is on the list.
Stilldrillin:
Thanks Tom!  :beer:

When you get to the appropriate part of the list, be careful. These things can drive you to distraction.........  :scratch:

David D
Brass_Machine:
Ya know David, I like the noisy part of that engine. Gives it some character (well, more character).

Nice job, it looks factory!

Eric
Stilldrillin:
Thanks Eric.
I've left a couple of borderline loose pivots. Just to add character.......   :smart:


Made some more progress.

A new left hand, half shaft. The original had been filed, enthusiastically.
Brass spacers, to position the crank throws.
Washers between moving parts.
And four, healthier looking nuts & washers, to hold the assembly together........




A new, better fitting replacement piston. To replace the undersize replacement(?) piston......




Opening out the cooling fins, for the larger o/d hot cap.
Hoping I don't finish up with a set of washers........




That fits, nicely.........




The engine is now finished. Just needing a new base board.

I found this redundant Maiwald base. Should be able to plug the holes, and tidy it.......




Not too long, now......  :)

Thanks for looking in!   :thumbup:
David D
AussieJimG:
Always worth watching David.

Jim
Navigation
Message Index
Next page
Previous page

Go to full version