| The Breakroom > The Water Cooler |
| CNC pc red light and won't turn on! |
| << < (4/6) > >> |
| Bluechip:
--- Quote from: John Rudd on January 02, 2014, 03:48:42 PM --- :worthless: --- Quote from: Pete. on January 02, 2014, 03:22:18 PM ---Fastest way I've found to mess up a PC is use a hoover to clean it out. I've ruined two like that until I found out why. --- End quote --- So, what was the reason for their demise? :scratch: --- End quote --- Bit :offtopic: but I suppose it's because you can get a very high electrostatic charge on the plastic nozzle. When I mill plastic and vaccy up, a lot of the bits jump onto the side of the thing rather than going up th'ole. I doubt if the bits were charged as they were sitting on the mill bed which is 'sort of' earthed. Presumably it's a tribo-electric effect as the bits go up the corrugated tubey thingy ???? Dave |
| John Rudd:
Of course .... I should have known that :doh: Off to kill myself......, :zap: |
| Bluechip:
--- Quote from: John Rudd on January 02, 2014, 05:52:25 PM ---Off to kill myself......, :zap: --- End quote --- Not so fast, Young Sir. T'was only a wild guess from an aged mind. ( Just loosening it up a bit with Glenmorangie. Seems to work better than Plus-Gas ... :ddb: ) Dave |
| raynerd:
I'm guessing my initial Hoover when the issue first arose did not help matters :-) :lol: :zap: |
| Doc:
Is it a laptop? I had that problem with my laptop and I found that the latch has a switch in it that got some debris in it and it was stuck don't know how that happened :coffee: anyway cleaned it out and everything booted up and worked fine after. |
| Navigation |
| Message Index |
| Next page |
| Previous page |