| The Breakroom > The Water Cooler |
| CNC pc red light and won't turn on! |
| << < (5/6) > >> |
| Pete.:
--- Quote from: Bluechip on January 02, 2014, 05:19:01 PM ---Bit :offtopic: but I suppose it's because you can get a very high electrostatic charge on the plastic nozzle. When I mill plastic and vaccy up, a lot of the bits jump onto the side of the thing rather than going up th'ole. I doubt if the bits were charged as they were sitting on the mill bed which is 'sort of' earthed. Presumably it's a tribo-electric effect as the bits go up the corrugated tubey thingy ???? Dave --- End quote --- Yup, static from the nozzle. I trashed a (back then) very expensive video card and some RAM by simply hoovering the dust off them. |
| awemawson:
I've always blown PC cases out with an airline and todate not been aware of creating any problems. Just take it outside the workshop door and blow the spiders out. Andrew |
| mattinker:
Airlines can give you damp problems. Regards, Matthew |
| Stilldrillin:
--- Quote from: awemawson on January 03, 2014, 02:52:49 AM ---I've always blown PC cases out with an airline and todate not been aware of creating any problems. Just take it outside the workshop door and blow the spiders out. Andrew --- End quote --- Fed up with the laptop fan, constantly howling at full stretch. I've recently risked blowing through the cooling slots, with the shop airline....... :palm: It's working quietly/ properly now. :thumbup: David D |
| Pete.:
Yup I blow mine out with an airline too. Even on a wet day I've had no problems. |
| Navigation |
| Message Index |
| Next page |
| Previous page |