| The Shop > Metal Stuff |
| Plasma Cutter |
| << < (4/6) > >> |
| awemawson:
--- Quote from: DaveH on December 13, 2013, 08:04:20 PM --- --- Quote from: awemawson on December 13, 2013, 05:20:11 PM ---Thanks for the link John, I've ordered the mask. Andrew --- End quote --- Andrew, You have ordered a mask from a company that states "doesn't post to South Africa" -seems a bit discriminant to me. (Shame on you) :lol: :lol: :lol: DaveH --- End quote --- Well just maybe they have their reasons :lol: Andrew |
| DaveH:
--- Quote from: awemawson on December 14, 2013, 04:09:41 AM --- --- Quote from: DaveH on December 13, 2013, 08:04:20 PM --- --- Quote from: awemawson on December 13, 2013, 05:20:11 PM ---Thanks for the link John, I've ordered the mask. Andrew --- End quote --- Andrew, You have ordered a mask from a company that states "doesn't post to South Africa" -seems a bit discriminant to me. (Shame on you) :lol: :lol: :lol: DaveH --- End quote --- Well just maybe they have their reasons :lol: Andrew --- End quote --- Someone here must have upset them - it wasn't me :lol: :beer: DaveH |
| Meldonmech:
Hi John Very well presented, that is a very attractive piece of equipment, already beginning to covet it. Cheers David |
| Dawai:
Neat. ,much more powerful than my $300 chinese one. CONSUMABLES thou are $40 for 250pc set for mine, was more before I put the CHEAP chinese torch on it. THE miller I had I could not afford them, I'd use a saw. TORCHES change out if you get tired of the "best ones" in yours and want to be cheap. it is either a 7 wire, or a 2 control wire torch. Pattern cutting, 2'x2' barrel sized cutter table is perfect for a small shop, Mine started out as a torch. now a plasma pattern. Now on a roll-about table instead of a barrel to catch the sparks. (sparks and metal dust are on floor now) I have a $100 cnc attachment for it drew up , will share when it works out into reality. Adjustable Manual circles with swivel, ball bearing "drawer sliders for saw cuts". I used to clamp a ruler on the pattern arm and trace it.. I normally just drag cut beside a ruler if I am in a hurry.. https://www.youtube.com/watch?v=FsgmJW2uX7s The circle cutter in action with close up of radius adjustor.. a simple cantilever swivel, the most important thing is to have the torch center under the tracer center, have the whole shebang level so it stays the same height over the cutting table. Grate is just flooring from a mezzaline floor. A drop, left over piece. BY the way, I have no respirator?? my iron content of my blood has been off the chart since I have been cutting with my plasma???? WTF?? |
| JD:
John, I have been watching your videos with interest, this thread has come at the wright time. I am about to buy a plasma cutter, just one question, have Plasma cutters with built in compressors got an advantage (apart form the obvious as having its own air supply) over the cutters without. John W |
| Navigation |
| Message Index |
| Next page |
| Previous page |