Thanks guys!
![:beer:](https://madmodder.net/Smileys/default/anim_32.gif)
I thought about using the existing table and using a slide, but as Pekka said the problem wasn't just interference , but also the table isn't wide enough to get the tool tip at the periphery of the wheel. The motor isn't reversible I don't think -- at least by me. A slide extension is possible off the table, but I think the action of the wheel will tend to kick it down on the left side, without support.
I could extend the current table, and I think that would work. I might still do that if I don't like my early morning wake up solution, which is to just remove the table and substitute a piece of angle iron bolted to the left side of the guard where the current pivot bolt is located. Very simple. Maybe too simple....
![:scratch:](https://madmodder.net/Smileys/default/icon_scratch.gif)
I do think this will allow me to lower the height -- another problem of the Cleve jig I chose to make. The tool tip ends up pretty high. Okay on a larger wheel -- but this one is only 5" -- 125mm. I could abandon the jig if I don't like it -- nothing sacred about it, and the idea of a slide and retaining the old table does still appeal. It's a good one. Well lets just see how the angle iron works out. Not much to it.
Thanks very much for the feedback! Nice to know a few people are following, and I appreciate all suggestions.
![:wave:](https://madmodder.net/Smileys/default/wave.gif)