Problematic and striving for an answer for last 13 years.
I have decent parting blades and holders from likes of Arno, Iscar, Manchester, Sandvik and some others. Have selection of tips with different angles, rakes, grades and neutral, left or right handed. All at best leave a minor burr. Some neutral tips leave full width of tip as a long burr. That's with a bored hole to break in to using 6082 aluminium with coolant.
One thing I haven't tried is speeding spindle up massively from 540rpm but suffer start issues at higher speeds. Most of the tips I have are used on 5 axis machines running up to 4000rpm.
To get rid of the burrs I usually use a knife as a deburrer, works wonders.