Yes I do........
How adept are you at electrics?
You will need to program the vfd as well.......
You will need a 10k potentiometer, a small box to put it in and three wires soldered to it, the three wires then connect to the vfd on the smaller of the set of terminals.....
The three wires connect to terminals 9,10 and 11. 10 goes to the centre connector of the pot
You need to change Parameter A01 to 002. The factory default is 000
Shout up if you need any more help...
Here's a link to the basics..
http://document.technique-achat.com/IMO/idrive/Mode_emploi_EN_FR_IT.pdf
