Hi there, all,
Some years ago, I was given this Emco 150 mm (6") rotary table.

I hadn't used it but I recently dug it out with a view to helping a friend with a job he was doing. In the course of looking it over, I realised that it needs some repair and refurbishment. It is complete with three division plates but I can't fit them because one of the fingers is stuck fast on its shaft. It does show edge-on in the photo but I've managed to get it right over the crease in the background paper!
I also managed to break the diecast operating handle on the detent spindle (see photo). [A plan is forming in my head as to how to make a replacement in mild steel.]
Please, please, does anyone out there have one of these tables? If so, I could use a bit of advice.
I had expected that there would be a fine adjustment knob and dial that could be fitted as an alternative to the division plate(s) and fingers - is there such an option?
I could also use any advice as to how to remove the stuck finger from its shaft.