Gallery, Projects and General > Project Logs
Mrs. Robinson, Revisited.......
Stilldrillin:
Eyebrows still intact Rob! :)
It all went very well, considering. :thumbup:
Sensible maximum........
Sensible minimum.......
Turned right up......
With those blue tips being blown upward, I think we need some more holes!
Mid setting. It ran the engine perfectly! :ddb: :ddb:
A bit of cosmetic work to do on the pot, and drill some more holes..... Job's a good un! :D
David D
vtsteam:
Wow, excellent burner! Nice looking, too. Congratulations! :thumbup: :clap:
Rob.Wilson:
Your cooking with gas now David
Thats a nice blue flame :clap: :clap: :clap: :clap:
Rob
Stilldrillin:
VT, Rob. Thanks Chaps! :beer:
Drilled a few extra holes.
Some of them, larger diameters. Until testing showed all the little blue flames were where they should be. :thumbup:
So, I reduced the oal height to 1/2", painted and finish assembled......
I'm a bit pleased with my first attempt at making a burner. :)
David D
Stilldrillin:
Well....... I'm still here! :wave:
Unfortunately, shop time and enthusiasm have been hard to find recently. :(
But, I've sourced a rubber wood base, and gas tank......
It runs ok, so far.......
Trying to get me head around plumbing the water tower. It needs up/ down pipes.
I intended to solder direct into the side. But, don't like that idea, now........
Cos it needs to unplug from the engine stubs......
Thought, mebbe I could solder in, boiler type bushings.
Then plumb lower pipe through a 90* elbow, and upper, bend to horizontal.......
Anyone else got a better idea? :scratch:
Are there any better looking, 8mm dia fixings, than these?
It's nice to be back! :thumbup:
David D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version