Gallery, Projects and General > Project Logs
Mrs. Robinson, Revisited.......
Stilldrillin:
As an addendum to the burner development.......
Gas power is usually used, to get as much heat as possible, under a boiler.
The problem is. I need a gentle, controllable, flame.
It finally dawned on me, what's needed, is lower gas velocity. Provided by larger holes!
As an experiment, I removed the rose insert. But it then insisted on burning, down inside the body.
Made a rose, with 3.5mm holes. (And 2mm central hole, which was already in the piece of bar).
The old, and new roses.......
No. 3 jet, giving a full flame. Which doesn't blow itself out when full on.......
But will turn down, sufficient for the engine to stop, with the burner still lit.......
Heading the right way, now. I think!
David D
Ross:
Getting there David, Lovely engine!
Stilldrillin:
--- Quote from: Ross on September 20, 2013, 03:47:17 PM ---Getting there David, Lovely engine!
--- End quote ---
Hi Ross.
Thanks Mate! :thumbup:
David D
vtsteam:
That looks really good, David! :thumbup: :clap:
Navigation
[0] Message Index
[*] Previous page
Go to full version