Afternoon lads
Not allot done , been a bad week
. Made up a few bushings ,three plane and three threaded 1/4 BSW pressed those into the jaws , then made the guide pins , hardened .
A quick polish and and these were then pressed into the fixed jaws
A bit of a side note , came in to the house to make a brew , found the wife had been doing something with here hair , spies this handy bottle in her hands .
Looking at it I thought hand wee oil bottle , So off came the label before Micktoon calls me gay AGAIN !
It has a nice small nozzle with screw on cap .
Back to the vice's ,rounded the ends of the moving jaw.
I sill need to make the screws , but thought I would have a bit mess on so i stuck a 1/4 screw in to try out one of the vice's .
had ago at filling the hole square
I need glasses
Cheers Rob