Gallery, Projects and General > Project Logs
Mini Lathe Upgrades
<< < (13/16) > >>
sckenny:
where do stand on bed mod.want to do same.tks,ken
OzzyRob:
On my lathe I added 2 thrust bearings to each side of the non driven lead screw bearing.
Once I set the leadscrew "preload" it never needed adjusting again.
Brass_Machine:
Well, it is starting to warm up. I am going to get back on this in the next few weeks...

The continued plans are:

1. New 4" spindle and bearings
2. Tapered gibs on the saddle
3. Brass Gibs on the cross slide
4. Replace the single half nut with a true 2 half nut system. LMS
5. Tailstock Cam lock LMS
6. Saddle lock

I am also going to check the bed for parallelism and straightness. I was reading a page a few weeks ago where someone else did that. I know I have seen people machine the bed on a larger mill (don't have access) butt his person did it my filing and scraping.

Anyone recall seeing a page like that? Can't seem to find it again.

Eric
Stilldrillin:
This mini mill one, Eric?

http://www.modelenginemaker.com/index.php?topic=3306.0

David D
Brass_Machine:
Nope, definitely a lathe. Definitely not a forum post. I had thought it was on gadget makers site, but can't seem to find it. This guy had a jig to hold a file to work the bed...
Navigation
Message Index
Next page
Previous page

Go to full version