Gallery, Projects and General > Project Logs
Mini Lathe Upgrades
<< < (16/16)
drmico60:
I have fitted the Real Bull 100mm (4") spindle to my Seig minilathe. It is a fairly straight forward job, see:

http://mikesworkshop.weebly.com/headstock-upgrade.html

Mike
catch_22:
I found your site not too long ago, I also have the same mill you have, upgraded the x and y axis to the longer travel. Turns out it was a good investment, as the first big job was to mill the 16" lathe bed motor slots. The original table was way too short to be stable.
Brass_Machine:

--- Quote from: drmico60 on May 23, 2014, 02:21:01 PM ---I have fitted the Real Bull 100mm (4") spindle to my Seig minilathe. It is a fairly straight forward job, see:

http://mikesworkshop.weebly.com/headstock-upgrade.html

Mike

--- End quote ---

Hiya Mike,

Yup, you were the one who inspired me to get that spindle. A bit of a pain to get it to the USA... but when I eventually get to it, I am sure it will be worth it. It is already a different machine with just the added mass of the longer bed and the full half nuts. When I am done, I won't want to sell it (tho I really want a 10x22).

Eric
catch_22:
And so the madness begins, the need to modify vs the bank account and time. I didn't take a lot of pics during my bed mod, only have a cheap cell phone, apologies for the fuzzy pics.
Navigation
Message Index
Previous page

Go to full version