Gallery, Projects and General > Project Logs
Mini Lathe Upgrades
<< < (5/16) > >>
Brass_Machine:
Well... I dropped the motor  :doh: :doh:

Thankfully, the only thing I broke was the pulley. Just made a LMS order, got a new pully and the motor mount for the 14" upgraded bed.

Eric
Stilldrillin:

--- Quote from: Brass_Machine on February 19, 2013, 08:19:02 PM ---Well... I dropped the motor  :doh: :doh:

Thankfully, the only thing I broke was the pulley. Just made a LMS order, got a new pully and the motor mount for the 14" upgraded bed.

Eric

--- End quote ---

Not a metric metric one Eric?  :scratch:

Incidentally. Don't forget the taper bearings, and the metal rear spacer.......  :thumbup:

David D
Brass_Machine:

--- Quote from: Stilldrillin on February 20, 2013, 02:19:38 AM ---...
Not a metric metric one Eric?  :scratch:
...

--- End quote ---

Well I deserved that! I didn't really explain myself earlier. What I meant by standard metric belt, was something that I could buy from McMaster Carr. When I needed to replace the belt before, I tried to get a metric replacement. For some reason, none of the metric belts (nor imperial for that matter) would fit. So I imagine that the Chinese lathes were using there own version of a metric belt... and not a 'standard' metric belt.

I did the tapered bearings when I replaced the belt. I also have a metal gear on the spindle (broke the plastic one).

What is the metal rear spacer??

Eric
Stilldrillin:

--- Quote from: Brass_Machine on February 20, 2013, 09:03:17 AM ---
What is the metal rear spacer??

Eric

--- End quote ---

This one Eric.......        http://madmodder.net/index.php/topic,7643.msg81872.html#msg81872

The original one's plastic. Allowing a little flex, between the bearing tapers, when a fair cut is applied.  :(

David D
Brass_Machine:
oooo. I like that! I will add that to the list!
Navigation
Message Index
Next page
Previous page

Go to full version