The Shop > Tools

Cincinnati no.2 (English made?) tool and cutter grinder - buy or pass?

<< < (5/6) > >>

PekkaNF:
Got the eManual (probably the same than I ordered) and tried to coin the name and piece accessories together.

I have the workhead in the garage. Haven't really had a look for it yet, but this is what I have:

These items I'm pretty sure I have a idea what  they are.

Looks like someone got 14 mm collet really well stuck into MT5 collet holder.

Also the ID grinder attachment bearings are shot. I think I have oilers in the wooden box.

Pekka

PekkaNF:
Following items are mystery to me in a large extent.

And some close-ups.

They must be important. :lol:

That ISO50 holder seems to be an adapter for same cone , but smaller dia.

Last item is probably a flat belt sheave, for what?

Pekka

mattinker:
I'm looking forward to this T&C grinder story coming out, I could easily have been persuaded to by one!

Keep us up dated!

Regaeds, Matthew

PekkaNF:
Thank you

I'm slowly derusting and cleaning up parts. Some contemplation and effort is here. I'm trying to learn some process here as well.
http://madmodder.net/index.php/topic,8236.0.html

Cleaning, organizing and derusting does not make very rivetting show and it's not anything I have any good knowledge to share. I'm thinkking to publish only the parts where I need help or get some good or very bad results.

I have been itching to ultrasound cleaning and soda baslting ans this is as good excuse as any.

I'm getting sidetrackked on parkerizing and blackening of tool shanks and such.....I'll start new thread on that after I study it a little furher and try something with household chemicals. Chemistry was not my forte in the school :bang:

Pekka

PekkaNF:
Stuf got cleaned and the monster got transported into my garage. I have been cleaning it and laest stuff was to check insulation restistance of the motor (pass with flying colors). Machine feets are ready to fit and only one more thing left before firing it.

What is the spindle oil?

How do I change it properly?

Anything else to know about the oil?

The plate is in Sweedish. but I don't regognize the oil. Does this picture tell anything abou the oil?

I bought the manual CD, but I have to prise other laptop from my daughters hands. Mine has no CD-drive.

Pekka

Update:
CMM Co. - N0. P-55

Rust and oxidation inhibited mineral oil. Viscosity 200 to 220 SSU at 100F.

Sounds - jep - it's oil?

Navigation

[0] Message Index

[#] Next page

[*] Previous page